USGS-NWQL: I-1114: Boron, dissolved, water, DCP
|
Official Method Name
|
Boron, atomic emission spectrometric, d-c plasma |
|---|---|
|
Current Revision
| Revised 1985 |
|
Media
|
WATER |
|
Instrumentation
|
Automated Spectrophotometer |
|
Method Subcategory
|
Inorganic |
|
Method Source
|
|
|
Citation
|
Methods for the Determination of Inorganic Substances in Water and Fluvial Sediments, Techniques of Water-Resources Investigations of the United States Geological Survey, Book 5, Chapter A1 Edited by Marvin J. Fishman and Linda C. Friedman |
|
Brief Method Summary
|
Boron is determined by a direct-reading emission spectrometer that utilizes a d-c argon plasma as an excitation source (Johnson and others, 1979a, b, 1980). A mixture of lithium chloride, sulfuric acid, and glycerin is added to samples and standards to provide a common background matrix and to compensate for viscosity changes. The liquid mixture is then converted by a ceramic nebulizer into a fine aerosol and introduced into the plasma via a plastic spray chamber and Pyrex injection tube. Boron is determined on the basis of the average of two replicate exposures, each of which is performed on a 10 second integrated intensity. Calibration is performed by standardization with a high- standard solution and a blank. |
|
Scope and Application
|
This method may be used to analyze finished water, natural water, and industrial water containing from 10 to 1000 ug/L of boron. Samples containing more than 1000 ug/L boron and/or with specific conductances greater than 10,000 uS/cm need to be diluted. |
|
Applicable Concentration Range
|
10-1000 ug/L |
|
Interferences
|
Stray-light effects in a high-resolution, single-element, d-c argon plasma emission spectrometer are found to be negligible. |
|
Quality Control Requirements
|
Calibrate instrument using calibration standards (CAL). Quality control samples (QCS) and laboratory blanks (LB) analyzed at a minimum of I each after every 10 samples. (Reference OFR 95-443). |
|
Sample Handling
|
Container Description: 250 mL Polyethylene bottle. Treatment and Preservation: Filter through 0.45-um filter; using filtered sample to rinse containers. |
|
Maximum Holding Time
|
180 days |
|
Relative Cost
|
Less than $50 |
|
Sample Preparation Methods
|
