USGS-NWQL: I-6302: Cyanide, recoverable-from-bottom-material, dry wt, colorimetric
|
Official Method Name
|
Cyanide, colorimetric, barbituric acid, automated-segmented flow |
|---|---|
|
Current Revision
| 1985 |
|
Media
|
SOILS/SEDIMENT |
|
Instrumentation
|
Automated Spectrophotometer |
|
Method Subcategory
|
Inorganic |
|
Method Source
|
|
|
Citation
|
Methods for the Determination of Inorganic Substances in Water and Fluvial Sediments, Techniques of Water-Resources Investigations of the United States Geological Survey, Book 5, Chapter A1 Edited by Marvin J. Fishman and Linda C. Friedman |
|
Brief Method Summary
|
This method is based on the chlorination of cyanide with chloramine-T and on the subsequent reaction with a pyridine-barbituric acid reagent (Goulden and others, 1972). This method detects simple cyanides only; therefore, any complex cyanides must first be broken down by passing the acidified sample solution through an ultraviolet digestion-distillation procedure. The distillation step also removes certain interferences. |
|
Scope and Application
|
This method may be used to determine cyanide in bottom material containing at least 0.5 mg/kg. |
|
Applicable Concentration Range
|
at least 0.5 mg/kg |
|
Interferences
|
Chloride interferes if its concentration exceeds 3,000 mg/L. Oxidizing agents may interfere. Glycine and urea at the 10-mg/L level do not interfere. A concentration of 10 mg/L sulfide increases the apparent cyanide concentration by approx 0.02 mg/L. Concentrations of sulfide greater than 10 mg/L interfere considerably. Thiocyanate is broken down to cyanide and sulfide by this procedure and, therefore, interferes on an equimolar basis. Sulfate concentrations of 4,000 mg/L do not interfere. Higher concentrations were not tested. |
|
Quality Control Requirements
|
Calibrate instrument using calibration standards (CAL). Quality control samples (QCS) and laboratory blanks (LB) analyzed at a minimum of I each after every 10 samples |
|
Sample Handling
|
Container Description: 500 mL Polypropylene bottle, wide-mouth Treatment and Preservation: No treatment, preservation or special shipping requirements |
|
Maximum Holding Time
|
180 days |
|
Relative Cost
|
Less than $50 |
|
Sample Preparation Methods
|
